It said agitating is preferred for 5 minutes for the primer and catalyst.
Supplied air again here...zero fumes.
One side is painted. I used a real small brush.
I propped them up on sockets to dry good.
I turned them over and painted the other side. I set the temperature in the garage at 72 degrees for the night. Tomorrow I'll spray the other pieces with the weld-thru primer, screw all the pieces together and weld them up. I'll follow the directions on the weld-thru primer when I spray them. The only thing that might be good about this is I'm using the products as they were intended and this will tell me when I take the welds apart how far that mig welder at different settings will burn that epoxy and the weld-thru primer back. Then I can coat my supports and floor pans accordingly.