This is kind of a short episode tonight. I figured I might as well put these on because I wanted to help a guy out on measurements for a four-speed floor hump. I also put those pictures on under Floor Hump. This way the bride won't get the ears back if I come in tomorrow and ask her to make more pages for my site. If you look in the corner of it, you'll see a gap. I'm going to close that gap up. I tried beating on it with a hammer and a punch and it won't go down flush, so I'm going to heat it up with an acetylene torch.
Here's another support that doesn't have the gap in the corner.
I took an old chisel I had and ground a radius and blunted it on the end so I can get that into the corner.
Another picture of the end of the chisel.
[ 1 ] [ 2 ] [ 3 ]
HOME
