A picture of the de-burring operation.
You can see where I ground off the burrs.
You can see where I ground the edge on the top of the pan, then when I weld it into the rocker it will go good.
The top side of the pan. I probably won't do a lot of de-burring at all because I have bare metal where the screw was raised up and it should weld just fine. Hopefully tomorrow I can drill some holes for the plug welds, make a couple of cuts on the front area of the pan and attempt to weld it. I'm not that good of a welder, but I'm going for it anyway.
You can see here where I've got bare metal to start welding with.