Pans are out and I put in new half supports. Before I weld the pans in I will
sandblast these supports.
I welded some square tubing to the four speed hole. The four speed fit so good
when I set the body down on the chassis that I wanted to keep that area rigid.
Same as above. But I tell you this jig is really nice to hold the body rigid and give
me working room underneath. But I screwed up...and did the chassis first, so I had to
make the jig to keep from scratching up the chassis.
Same picture...all I did was spot weld them.
You can see the new and the old support. It's welded solid on both sides.
[ 1 ] [ 2 ] [ 3 ]
[ 4 ] [ 5 ]
[ 6 ] [ 7 ]
[ 8 ]
[ 9 ] [ 10 ]
[ 11 ] [ 12 ]
[ 13 ] [ 14 ]
HOME
Pans are out and I put in new half supports. Before I weld the pans in I will sandblast these supports.
I welded some square tubing to the four speed hole. The four speed fit so good when I set the body down on the chassis that I wanted to keep that area rigid.
Same as above. But I tell you this jig is really nice to hold the body rigid and give me working room underneath. But I screwed up...and did the chassis first, so I had to make the jig to keep from scratching up the chassis.
Same picture...all I did was spot weld them.
You can see the new and the old support. It's welded solid on both sides.